Endress+Hauser Proline Promass A 100 PROFINET Operating Instructions Manual page 98

Diagnostics and troubleshooting
Diagnostic information
No.
082 Data storage
Measured variable status
Quality
Quality substatus
Coding (hex)
Status signal
Diagnostic behavior
Diagnostic information
No.
083 Memory content
Measured variable status
Quality
Quality substatus
Coding (hex)
Status signal
Diagnostic behavior
Diagnostic information
No.
140 Sensor signal
Measured variable status [from the factory]
Quality
Quality substatus
Coding (hex)
Status signal
Diagnostic behavior
1) Diagnostic behavior can be changed. This causes the overall status of the measured variable to change.
98
Short text
Bad
Maintenance alarm
0x24 to 0x27
F
Alarm
Short text
Bad
Maintenance alarm
0x24 to 0x27
F
Alarm
Short text
1)
Good
Ok
0x80 to 0x83
S
Alarm
Remedy instructions
1. Check module connections
2. Contact service
Remedy instructions
1. Restart device
2. Contact service
Remedy instructions
1. Check or change main electronics
2. Change sensor
Proline Promass A 100 PROFINET
Influenced measured
variables
• Carrier mass flow
• Concentration
• Density
• Dynamic viscosity
• Kinematic viscosity
• Mass flow
• Sensor integrity
• Reference density
• Corrected volume flow
• Target mass flow
• Temp. compensated
dynamic viscosity
• Temp. compensated
kinematic viscosity
• Temperature
• Volume flow
Influenced measured
variables
• Carrier mass flow
• Concentration
• Density
• Dynamic viscosity
• Kinematic viscosity
• Mass flow
• Sensor integrity
• Reference density
• Corrected volume flow
• Target mass flow
• Temp. compensated
dynamic viscosity
• Temp. compensated
kinematic viscosity
• Temperature
• Status
• Volume flow
Influenced measured
variables
• Carrier mass flow
• Concentration
• Density
• Dynamic viscosity
• Kinematic viscosity
• Mass flow
• Sensor integrity
• Reference density
• Corrected volume flow
• Target mass flow
• Temp. compensated
dynamic viscosity
• Temp. compensated
kinematic viscosity
• Temperature
Endress+Hauser