Endress+Hauser Proline Promass A 100 PROFINET Operating Instructions Manual page 61

Proline Promass A 100 PROFINET
Endress+Hauser
9.3.5 Startup configuration
If startup configuration is enabled, the configuration of the most important device
parameters is taken from the automation system and used. The following configurations
are taken from the automation system.
Startup configuration
(NSU)
• Management:
• Software revision
• Write protection
• Web server functionality
• System units:
• Mass flow
• Mass
• Volume flow
• Volume
• Corrected volume flow
• Corrected volume
• Density
• Reference density
• Temperature
• Pressure
• Concentration application package:
• Coefficients A0 to A4
• Coefficients B1 to B3
• Medium type
• Sensor adjustment
• Process parameter:
• Damping (flow, density, temperature)
• Flow override
• Low flow cut off:
• Assign process variable
• Switch-on/switch-off point
• Pressure shock suppression
• Empty pipe detection:
• Assign process variable
• Limits
• Response time
• Max. damping
• Corrected volume flow calculation:
• External reference density
• Fixed reference density
• Reference temperature
• Linear expansion coefficient
• Square expansion coefficient
• Measuring mode:
• Medium
• Gas type
• Reference sound velocity
• Temperature coefficient sound velocity
• External compensation:
• Pressure compensation
• Pressure value
• External pressure
• Alarm delay
• Diagnostic settings
• Diagnostic behavior for diverse diagnostic information
• Petroleum application package:
• Petroleum mode
• Water density unit
• Water reference density unit
• Oil density unit
• Oil sample density
• Oil sample temperature
• Oil sample pressure
• Water sample density
• Water sample temperature
• API commodity group
• API table selection
• Thermal expansion coefficient
System integration
61