Endress+Hauser Proline Promass A 100 PROFINET Operating Instructions Manual page 136

Technical data
Terminal assignment
Supply voltage
136
Startup configuration
Startup configuration
(NSU)
16.5 Power supply
→  29
The power unit must be tested to ensure it meets safety requirements (e.g. PELV, SELV).
If startup configuration is enabled, the configuration of the most important
device parameters is taken from the automation system and used.
The following configuration is taken from the automation system:
• Management
• Software revision
• Write protection
• System units
• Mass flow
• Mass
• Volume flow
• Volume
• Corrected volume flow
• Corrected volume
• Density
• Reference density
• Temperature
• Pressure
• Concentration application package
• Coefficients A0 to A4
• Coefficients B1 to B3
• Sensor adjustment
• Process parameters
• Damping (flow, density, temperature)
• Flow override
• Low flow cut off
• Assign process variable
• Switch-on/switch-off point
• Pressure shock suppression
• Empty pipe detection
• Assign process variable
• Limit values
• Response time
• Max. damping
• Corrected volume flow calculation
• External reference density
• Fixed reference density
• Reference temperature
• Linear expansion coefficient
• Square expansion coefficient
• Measuring mode
• Medium
• Gas type
• Reference sound velocity
• Temperature coefficient sound velocity
• External compensation
• Pressure compensation
• Pressure value
• External pressure
• Diagnostic settings
• Diagnostic behavior for diverse diagnostic information
Proline Promass A 100 PROFINET
Endress+Hauser