Endress+Hauser Proline Promass A 100 PROFINET Operating Instructions Manual page 86

Operation
Parameter
Control Totalizer 1 to n
Preset value 1 to n
Totalizer value
Reset all totalizers
* Visibility depends on order options or device settings
86
Preset value 1 to n
Totalizer value 1 to n
Reset all totalizers
Parameter overview with brief description
Prerequisite
A process variable is selected
in the Assign process variable
parameter of the Totalizer
1 to n submenu.
A process variable is selected
in the Assign process variable
parameter of the Totalizer
1 to n submenu.
One of the following options is
selected in the Assign process
variable parameter of the
Totalizer 1 to n submenu:
• Volume flow
• Mass flow
• Corrected volume flow
*
• Target mass flow
*
• Carrier mass flow
–
11.6.1 Function scope of "Control Totalizer" parameter
Options Description
Totalize The totalizer is started or continues running.
Reset + hold The totaling process is stopped and the totalizer is reset to 0.
1)
Preset + hold The totaling process is stopped and the totalizer is set to its defined start value
from the Preset value parameter.
Reset + totalize The totalizer is reset to 0 and the totaling process is restarted.
1)
Preset + totalize The totalizer is set to the defined start value in the Preset value parameter and the
totaling process is restarted.
1) Visible depending on the order options or device settings
Description
Control totalizer value.
Specify start value for totalizer.
Dependency

The unit of the selected
process variable is
defined in the Unit
totalizer parameter for
the totalizer.
Displays the current totalizer
counter value.
Reset all totalizers to 0 and
start.
Proline Promass A 100 PROFINET
→  86
→  86
→  86
Selection / User Factory setting
entry / User
interface
• Totalize –
• Reset + hold
• Preset + hold
• Reset + totalize
• Preset + totalize
• Hold
Signed floating-point Depends on country:
number • 0 kg
• 0 lb
Signed floating-point –
number
• Cancel –
• Reset + totalize
Endress+Hauser