Endress+Hauser Proline Promass A 100 PROFINET Operating Instructions Manual page 78

Commissioning
Parameter
Totalizer operation mode
Failure mode
* Visibility depends on order options or device settings
Parameter
Define access code
Device reset
78
Prerequisite
In the Assign process variable
parameter, one of the
following options is selected:
• Mass flow
• Volume flow
• Corrected volume flow
*
• Target mass flow
*
• Carrier mass flow
In the Assign process variable
parameter, one of the
following options is selected:
• Mass flow
• Volume flow
• Corrected volume flow
*
• Target mass flow
*
• Carrier mass flow
10.7.5 Using parameters for device administration
The Administration submenu systematically guides the user through all the parameters
that can be used for device administration purposes.
Navigation
"Setup" menu → Advanced setup → Administration
‣
Administration
Define access code
Device reset
Parameter overview with brief description
Description
Define release code for write access to parameters.
Reset the device configuration - either entirely or in part - to a
defined state.
10.8 Simulation
Via the Simulation submenu, it is possible to simulate various process variables in the
process and the device alarm mode and verify downstream signal chains (switching valves
or closed-control loops). The simulation can be performed without a real measurement (no
flow of medium through the device).
Description
Select totalizer calculation
mode.
Define the totalizer behavior in
the event of a device alarm.
Proline Promass A 100 PROFINET
Selection Factory setting
• Net flow total –
• Forward flow total
• Reverse flow total
• Last valid value
• Stop –
• Actual value
• Last valid value
→  78
→  78
User entry / Selection
0 to 9 999
• Cancel
• To delivery settings
• Restart device
• Delete powerfail storage
• Delete T-DAT
• Delete factory data
Endress+Hauser