Table of Contents
Advertisement
Chapter
2
QUICK SETUP Menu
Print Mode
This menu item specifies the type of printing to be done.
•
Transfer. Indicates thermal transfer printing (ribbon installed).
•
Direct. Indicates direct thermal printing (no ribbon) and requires special
heat sensitive media.
The default is Transfer, unless your printer is shipped as direct thermal only
(no ribbon motors installed).
NOTE: The Print Mode menu item does not appear for direct thermal only
Media Handling
This menu item specifies how the printer will handle the media (labels or tag
stock).
•
Tear-Off Strip. Printer prints on the media and sends it out the front until
the print buffer is empty, then positions the last label over the tear bar for
removal.
•
Tear-Off. After each label is printed, the printer positions the label over
the tear bar and waits for you to tear off the label before printing the next
one (on-demand printing). A "Remove Label" message displays to remind
you to remove the label before the next one can be printed.
•
Peel-Off. When the optional rewinder is installed, prints and peels die cut
labels from the liner without assistance. The printer waits for you to
remove the label before printing the next one (on-demand printing). The
label liner is rewound on the internal rewinder. A "Remove Label"
message displays to remind you to remove the label before the next one
can be printed.
•
Cut. When the optional media cutter is installed, it automatically cuts
media after each label is printed or can cut after a specified number of
labels have been printed using a software cut command. It cuts
continuous roll paper, labels, or tag stock.
NOTE: The Cut option is hidden when RFID Reader is set to Enable in the
•
Continuous. Printer prints on the media and sends it out the front.
The default is Tear-Off Strip.
Paper Feed Shift
This menu item represents the distance to advance a label (+ shift) or pull
back (– shift) when the Tear-Off Strip, Tear-Off, Peel-Off, or Cut Media
Handling option is enabled. The allowable range is –0.50 inches to the current
Label Length value setting up to a maximum of 12.80 inches in 0.01 inch
increments.
The default is 0.00 inches.
32
printers.
RFID CONTROL menu.
Advertisement
Table of Contents
