Table of Contents
Advertisement
Chapter 4
LinePrinter Plus Emulation
Host Command
This parameter allows you to block certain host commands from
being acknowledged by the printer.
•
Enable (default). All host commands are acknowledged by the
printer.
•
Ignore All. All host commands are ignored by the printer.
•
Ignore CPI. All CPI commands sent by the host are ignored by
the printer.
•
Ignore LPI. All LPI commands sent by the host are ignored by
the printer.
•
Ignore Unidir. All Unidirectional commands sent by the host
are ignored by the printer.
Font Attributes
Typeface
•
Data Processing. A general purpose font printing out at
120 dpi horizontally and 72 dpi vertically. The width of the font
will vary with each cpi.
•
NLQ. A high quality font printing at 180 dpi horizontally and
96 dpi vertically. This font has serifs and the width of the font
varies with the cpi.
•
OCR-A / OCR-B. Optical character recognition fonts printing at
120 dpi horizontally and 144 dpi vertically. Both fonts print only
at 10 cpi.
•
High Speed. A draft quality font printing at 120 dpi horizontally
and 48 dpi vertically. The width of the font varies with the cpi.
•
NLQ Sans Serif. A high quality font printing at 180 dpi
horizontally and 96 dpi vertically. This font prints without serifs.
The width of the font varies with the cpi.
•
High Speed 100. A draft quality font printing at 100 dpi
horizontally and 48 dpi vertically. When chosen from the front
panel, it defaults to 10 cpi. The cpi can then be varied, but the
width will not change.
184
Advertisement
Table of Contents
