Table of Contents
Advertisement
The shipping kit for this printer includes 220 ohm pull-up and 330 ohm
pull-down alternate terminating resistors. If you install the 220 ohm pull-
up resistor, you must also install the 330 ohm pull-down resistor. Table
12 lists the three terminating resistor configurations you can install:
Table 12. Terminating Resistor Configurations
Configuration
Factory Default
Alternate 1
Alternate 2
Removal And Installation
The procedure for removing and installing terminating resistors is
provided in your Maintenance Manual.
CAUTION
This is an involved maintenance procedure. To avoid damage to
the equipment, only a trained technician should perform this
procedure.
Terminating Resistor Configurations
Pull-Up (RP1)
Pull-Down (RP2)
470 ohm
1K ohm
220 ohm
330 ohm
1K ohm
none
291
Advertisement
Table of Contents
