Printronix P5005B User Manual page 266

Chapter 4
NETWORK SETUP MENU
Ethernet Speed
This menu option only appears if a 10/100Base-T network interface
card (NIC) is installed. The Ethernet Speed menu allows
compatibility with different systems and networks. The factory
default is Auto Select.
•
Auto Select. (default) This setting tells the 10/100Base-T NIC
to perform an auto detection scheme and configure itself to be
10 Half Duplex, 10 Full Duplex, 100 Half Duplex, or 100 Full
Duplex.
•
10 Half Duplex. Tells the 10/100Base-T NIC to communicate
at 10 Megabits per second using half duplex.
•
10 Full Duplex. Tells the 10/100Base-T NIC to communicate at
10 Megabits per second using full duplex.
•
100 Half Duplex. Tells the 10/100Base-T NIC to communicate
at 100 Megabits per second using half duplex.
•
100 Full Duplex. Tells the 10/100Base-T NIC to communicate
at 100 Megabits per second using full duplex.
Job Control
The job control mode has three options:
•
Standard (default). The NIC waits for the printer to finish
receiving the current job before sending another job. The status
line shows "done" when the job is completely received by the
NIC. This is the default.
•
Enhanced. The NIC waits for the printer to finish receiving the
current job before sending another job. The status line shows
"done" when the job is fully printed.
•
Off. No job synchonization between the NIC and the printer.
266