Busy On Strobe - Printronix P5005B User Manual

Busy On Strobe

•
Enable (default). Asserts a busy signal after each character is
received.
•
Disable. Asserts a busy signal only when the print buffers are
full.
Latch Data On
Specifies whether the data is read on the leading or trailing edge of
the data strobe signal.
Prime Signal
•
Enable (default). The parallel port will perform a warm start
(reboot) if the host asserts the prime signal.
•
Disable. The parallel port will not perform a warm start (reboot)
if the host asserts the prime signal.
TOF Action
•
Reset (default). A form feed is performed before a warm start
when the prime signal is asserted from the host. This setting is
used only if the prime signal parameter is enabled.
•
Do Nothing. Nothing occurs before a warm start when the
prime signal is asserted from the host.
Buffer Size in K
Configures the amount of memory allocated for the Centronics
parallel port buffer. You can specify between 1 and 16 Kbytes, in
1-Kbyte increments.
Centronics (Parallel) Submenu
241