Esc C Sequence - Printronix P5005B User Manual

P5000 series line matrix printers psa3
Hide thumbs Also See for P5005B:
Table of Contents

Advertisement

Chapter 4
ANSI Emulation
Character Set
This parameter selects a character set for the ANSI emulation.
Note that when 0876 OCR-A or 0877 OCR-B is selected as the
print language, the Font Attributes Typeface parameter is changed
to OCR-A or OCR-B, respectively. Character sets are shown in
detail in the Character Sets Reference Manual .
Printer Select
ON = DC1/OFF = DC3 (default). Disables the printer when a
DC1 control code is received, and enables the printer when a
DC3 control code is received.
Disable. Ignores the DC1 and DC3 control codes.

ESC c Sequence

Enable (default). An ESC c code received from the host resets
the printer parameters to the factory defaults.
Disable. An ESC c code received from the host is ignored.
Reset Cmd CFG Ld
When the printer receives a host data stream reset command
(ESC @ or ESC[K) in addition to resetting printer variables, the
selected configuration will be loaded.
Disable (default). The active emulation parameters are loaded
when the reset command is executed.
Power-Up Config. The power-up configuration is loaded when
the reset command is executed.
Current Config. The currently selected configuration is loaded
when the reset command is executed.
Factory Config. The factory installed configuration is loaded
when the reset command is executed.
218

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P5005B and is the answer not in the manual?

This manual is also suitable for:

P5210P5215P5220P5224P5010Psa3 ... Show all

Table of Contents