Printronix P5005B User Manual page 319

Table 17. LCD Message Troubleshooting Table
Can User
Displayed Message
Correct?
SHUT DRVR CIR* No
SHUTL INV CMD* No
SHUTL INV PARM* No
SHUTTLE JAM Yes
SHUTTLE TYPE No
NOT SUPPORTED*
SOFTWARE No
ERROR*
STACK No
OVERFLOW*
Explanation
The shuttle driver Contact your authorized
circuit on the PSA3
service representative.
controller board is
drawing too much
current.
Fatal firmware Contact your authorized
error on controller
service representative.
board.
Fatal firmware Contact your authorized
error on controller
service representative.
board.
No shuttle Check for obstruction to
movement or shuttle, a twisted ribbon,
shuttle moving at or forms thickness lever
wrong speed. closed too tightly. If fault
source is not apparent,
contact your authorized
service representative.
The shuttle type Contact your authorized
was not properly
service representative.
detected at
powerup.
Application Contact your authorized
software tried to
service representative.
perform illegal
printer function, or
damaged logic
circuits found on
controller board.
Fatal firmware Contact your authorized
error on controller
service representative.
board.
Fault Messages
Solution
1
1
1
1
1
1
319