Translation Tbl - Printronix P5005B User Manual

Char Set Select
Specifies the print language used by the printer. Character sets are
shown in detail in the Character Sets Reference Manual .

Translation Tbl

Prints out SCS and DSC/DSE tables of the Coax interface's current
character set. This operation is valid only when the Coax interface
is selected as the current interface (see "HOST INTERFACE" on
page 236).
Active Char Set
Selects which group of character sets (Primary or Secondary) will
be active. Secondary Set is the default.
Prt Partial Line
•
Enable (default). Forces the printer to print if a partial line is in
the printer (i.e., line not ending with a LF).
•
Disable. The last partial line of data will not be printed.
PA1
PA1 is only valid when the printer is in the offline state and the coax
Systems Network Architecture Character String (SCS) data stream
is active. This function displays the "PA1 ENABLED" message
when the ENTER key is pressed and sends a special operator
request to the host when the printer is put back in Online mode.
Refer to the Coax/Twinax Programmer's Reference Manual for
more information about SCS.
NOTE: Selecting the PA1 menu item again ("PA1 DISABLED"
appears on the operator panel) or selecting the PA2 menu
item will reset the pending PA1 function.
Coax Emulation
143