CPI/LPI Select
This parameter lets you specify the characters per inch (cpi) and lines per
inch (lpi) values. The defaults are 10 cpi, 6 lpi, and 6.7 cpi for Hanzi, 15 cpi,
8.0 lpi, and 7.5 cpi for Kanji.
Host Command
•
Enable. Enables all host printing commands.
•
Ignore All. This function treats all control codes and printing commands
as the data.
•
Ignore CPI. This function ignores the CPI selection commands only
(e.g., ESC M, ESC P, and ESC G).
•
Ignore LPI. This function ignores the LPI selection commands only
(e.g, ESC 2 and ESC 0).
•
Ignore Unidirectional. The default. All unidirectional commands sent by
the host are ignored by the printer.
Font Attributes
This submenu allows you to define the following font attributes: typeface,
proportional spacing, bold print, and italic print. You can also specify if the
zero character will print with a slash.
Styling Type defines the font style in the particular printer. Different printers
may have different default styling types.
High Density enabled will allow the LQ typeface to print in higher print density.
It will not take effect when other typefaces are selected.
Text position specifies where the text will be positioned in the line space.
When set to Top of Line, text will be positioned at the top of the line space.
When set to Bottom of Line, the text will be positioned as if it were at the
bottom of a 6 lpi line space. The following example shows both Top of Line
and Bottom of Line text positions:
Dot
Row
Top of Linespace
1
2
3
4
5
6
7
8
Bottom of 8 LPI Linespace
9
10
11
Bottom of 6 LPI Linespace
12
The option "DBCS / ASCII mode" specifies the operating mode of the Hanzi
printer. If it is set to DBCS mode, it can print double-byte characters as well as
a limited number of single-byte characters. Otherwise, it can only print single-
byte characters. Refer to "DBCS Mode" on page 40 for more details.
Text Position
Top of Line
Bottom of Line
Hanzi Big5 LP+ Menu
1
Text Position
27