Snmp Group Access Table Configuration - TRENDnet TL2-E284 User Manual

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
SNMP Version
Auth-Protocol
Priv-Protocol
Click ADD to submit the changes and the Reset button will clear the information. Select and click Delete to
remove an existed entry.

SNMP Group Access Table Configuration

This page is to configure the access settings of a SNMP group.
Parameter
Group Name
Read View Name
Write View Name
Notify View Name
Security Model
Security Level
Click ADD to submit the changes and the Reset button will clear the information. Select and click Delete to
remove an existed entry.
5-5
Specify the SNMP version to be used, which can be v1, v2c, or v3. Select
„encrypted' if the encryption for user authentication is needed. Once the
encryption is enabled, then you can set the authentication and privilege
algorithm and passwords.
Specify the authentication algorithm from MD5 or SHA algorithm, and the
password.
Specify the privilege encryption algorithm from DES or none, and the
password.
Figure 15 – System > SNMP > Group Access Table
Description
SNMP group name
The name of group (view) has read privilege and is allowed to access the
specified MIB object groups.
The name of group (view) has write privilege and is allowed to access the
specified MIB object groups.
The name of group (view) can receive SNMP Trap messages and is allowed
to access the specified MIB object groups.
Specify the SNMP version to be used, which can be v1, v2c, or v3.
Specify if authentication and encryption are needed for SNMP messages.
NoAuthNoPriv – Neither authentication or encryption is needed. It is the
default setting.
AuthNoPriv - Authentication is required for the SNMP messages. It is
selectable only when SNMPv3 is specified.
AuthPriv – Both authentication and encryption are required for the SNMP
messages. It is selectable only when SNMPv3 is specified.