La Port Statemachine Information; La Load Balancing Policy - TRENDnet TL2-E284 User Manual

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
Parameter
Select
Port
Port Priority
Port Identifier
Mode
Activity
Timeout
Wait Time (secs)
Bundle State
Click Apply to submit the changes.
Click 1-12, 13-24, 25-28 to configure LA port settings for corresponding ports.

LA Port StateMachine Information

This page is to display the LA state of each port.

LA Load Balancing Policy

Parameter
Select
Port Channel
Selection Policy
6-17
Description
Select a port to submit the changes.
Port ID.
Specify the link aggregation port priority of this port. Possible values are
0-65535. Default is 128.
Port ID.
Specify the mode of this port channel. Possible options are Lacp, Manual and
Disable.
Specify the LACP mode of the port. Select Active to activate the LACP
negotiation; select Passive that LACP negotiation starts only when LACP
packet is received. Default is Active.
To choose the LACP timeout period when no packet receive from peer. Long
specifies a long time out value. LACP PDU will be sent every 30 seconds and
LACP timeout value is 90 seconds. Short specifies a short time out value.
LACP PDU will be sent every 1 seconds and LACP timeout value is 3 seconds
Specify the period that ports get aggregated after receiving LACP PDU.
Possible value is 0-10 seconds. Default is 2.
Specify the current LA state of this port. And the states descriptions are:
Up in Bundle - This port is an active member of a port channel.
Up Individual - This port is not a member of any port channel but its operation
state is Up.
Standby - This port is a standby member of a port channel.
Down - This port operation state is down.
Figure 52 – Layer2 Management > LA > Port State Info
Figure 53 – Layer2 Management > LA > Load Balancing
Description
Select a port channel to apply the configuration change.
Port Channel ID.
Select a load balancing algorithm for the port channel. The traffic will hash
between the member ports of a port channel based on the rule selected. The
options are MAC Source, MAC Destination, MAC Source and Destination,
IP Source, IP Destination, and IP Source and Destination. Default is MAC
Source and Destination.