Show Mac-Address-Table Static Multicast - TRENDnet TL2-E284 User Manual

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
Example
Command History

show mac-address-table static multicast

Command
Syntax Description
Command Modes
User Guidelines
Example
33-7
switch# show mac-address-table dynamic unicast vlan 1
Vlan Mac Address
---- -----------
1 00:18:8b:bf:75:30
1 00:19:cb:d2:f2:75
1 00:22:15:0c:85:6c
Total Mac Addresses displayed: 3
Version History
1.00.001 This command was introduced
To display the static multicast MAC address in MAC address table.
show mac-address-table static multicast [vlan <vlan-range>]
[address <aa:aa:aa:aa:aa:aa>] [{interface <interface-type>
<interface-id>}]
vlan vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
Privileged EXEC Mode
System will display all static multicast MAC addresses when executing the
command without given VLAN, address and interface parameters.
switch# show mac-address-table static multicast vlan 1
Static Multicast Table
----------------------
Vlan : 1
Mac Address : 11:22:33:44:55:66
Member Ports : Fa0/5
Status : Permanent
------------------------------------------------
Vlan : 1
Mac Address : 11:33:55:77:99:bb
Member Ports : Fa0/7
Status : Permanent
------------------------------------------------
Total Mac Addresses displayed: 2
Type Ports
---- -----
Learnt Fa0/3
Learnt Fa0/11
Learnt Fa0/11
To display MAC addresses belong to a specific VLAN
range.
Specify a specific MAC address to display.
To display MAC addresses under a specific port.
Interface-type including Fa (Fast Ethernet), Gi (Gigabit
Ethernet) or port-channel.
Interface-id is slot/port number or port channel ID.