Igmp Snooping; Igmp Snooping Configuration; Igmp Snooping Timer Configuration - TRENDnet TL2-E284 User Manual

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots

IGMP Snooping

IGMP Snooping Configuration

This page is to configure the IGMP Snooping global settings.
Parameter
System Control
Click Start to start or shutdown the IGMP Snooping globally.
Parameter
Select
IGMP Snooping Status
Operational Status
Snooping Mode
Report Forwarding
Retry Count (1~5)
Query Transmit On TC
Click Apply to submit the changes.

IGMP Snooping Timer Configuration

This page is to configure the IGMP Snooping timers.
6-22
Figure 59 – Layer2 Management > IGMP Snooping > Basic Settings
Description
To activate or shutdown IGMP snooping of the Switch. Select Start to activate
the function, Shutdown to shutdown it. Default is Start.
Description
Select a line to change the configuration.
To enable or disable IGMP Snooping globally. Default is enabled.
Specify the operational status of IGMP snooping function.
Specify the Snooping mode of IGMP snooping function.
Specify which port to forward the IGMP report. Select All Ports to forward the
report to all ports, Router Ports to forward the reports to IGMP router ports
only. Default is Router Ports.
To set the maximum retries for group specific queries which sent to a port
received an IGMPv2 leave message. The possible number is 1-5 times.
Default is 2.
Specify if the IGMP queries will still be sent when STP topology change
happens. Select Enable to transmit the queries, Disabled not to transmit.
Default is Disabled.