Set Garp Timer - TRENDnet TL2-E284 User Manual

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
Syntax Description
Default Settings
Command Modes
User Guidelines
Example
Command History

set garp timer

Command
Syntax Description
Default Settings
Command Modes
User Guidelines
Example
Command History
27-2
interface-type
Specify which port to enable GVRP function.
interface-id
Interface-type including Fa (Fast Ethernet) or Gi (Gigabit
Ethernet).
Interface-id is slot/port number.
enable
Enables GVRP on the port.
disable
Disables GVRP on the port.
Enable
Global Configuration Mode
If port GVRP is disabled, but global GVRP is enabled, any GVRP packet received
by this port will be discarded and no GVRP registrations will be propagated from
other ports
switch(config)# set port gvrp fa 0/1 disable
Version History
1.00.001 This command was introduced
To set the GARP timers on an interface.
set garp timer {join <time in milli seconds(10-1073741810)> |
leave <time in milli seconds(30-2147483630)> | leaveall<time
in milli seconds(40-2147483640)>}
join <time in
seconds(10-1073741810)>
leave <time in
seconds(30-2147483630)>
leaveall<time in milli
seconds(40-2147483640)>
Join - 20
Leave - 60
Leaveall - 100
Interface Configuration Mode
1. Leave timer must be greater than 2 times join time.
2. Leaveall time must be greater than Leave time
switch(config-if)# set garp timer join 50
Version History
1.00.001 This command was introduced
milli
Specify the join time of GARP.
milli
Specify the leave time of GARP.
Specify the leaveall time of GARP.