Snmp Trapinfo; Snmp User - TRENDnet TL2-E284 User Manual

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots

snmp trapinfo

Command
Syntax Description
Default Settings
Command Modes
Example
Command History

snmp user

Command
Syntax Description
17-6
To configure the SNMP Trap setting of a community user, and no form deletes the
setting.
snmp trapinfo community-user <UserName> IPAddress {<IPAddress>
| <IP6Address>} security-model {v1 | v2c | v3 {auth | noauth
| authpriv}} [{volatile | nonvolatile}]
no snmp trapinfo community-user <UserName> security-model {v1
| v2c | v3}
community-user
UserName
IPAddress IPAddress
IPAddress
IP6Address
security-model v1
security-model v2c
security-model
auth
security-model
noauth
security-model
authpriv
volatile
nonvolatile
None
Global Configuration Mode
switch(config)# snmp trapinfo community-user oper ipAddress
172.17.0.168 security-model v2c nonvolatile
Version History
1.00.001 This command was introduced
To create a SNMP user and no form deletes the user.
snmp user <UserName> [auth {md5 | sha} <passwd>
<passwd>]] [{volatile | nonvolatile}]
no snmp user <UserName>
UserName
auth md5
auth sha
SNMP community-user name
IPv4 address of SNMP Trap messages to be sent to
IPv6 address of SNMP Trap messages to be sent to
SNMP version 1 is to be used
SNMP version 2v is to be used
v3
SNMP version 3 is to be used, and authentication is
used for the SNMP messages
v3
SNMP version 3 is to be used, and no authentication
is used for the SNMP messages
v3
SNMP version 3 is to be used, and authentication
and encryption are used for the SNMP messages
Store in volatile memory
Store in nonvolatile memory
SNMP user name
Specify MD5 as authentication algorithm
Specify Secure Hash as authentication algorithm
[priv DES