Lacp Timeout; Lacp Wait-Time - TRENDnet TL2-E284 User Manual

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
User Guidelines
Example
Command History

lacp timeout

Command
Syntax Description
Default Settings
Command Modes
Example
Command History

lacp wait-time

Command
Syntax Description
Default Settings
Command Modes
30-4
The port priority decides the standby or active links in a aggregation when the
number of member port exceeds the maximum number of the etherchannel that
Switch supported.
switch(config-if)# lacp port-priority 1
Version History
1.00.001 This command was introduced
To choose the LACP timeout period when no packet receive from peer..
lacp timeout {long | short }
no lacp timeout
long
Specify a long time out value. LACP PDU will be sent every
30 seconds and LACP timeout value is 90 seconds
short
Specify a short time out value. LACP PDU will be sent every 1
seconds and LACP timeout value is 3 seconds
Long
Interface Configuration Mode
switch(config-if)# lacp timeout short
Version History
1.00.001 This command was introduced
The period that ports get aggregated after receiving LACP PDU.
lacp wait-time <0-10>
no lacp wait-time
0-10
Specify the wait time in seconds.
2 seconds
Interface Configuration Mode