Ip Settings; Snmp Host Settings; Surveillance Settings - TRENDnet TPE-3012LS User Manual

TRENDnet User's Guide

Surveillance Settings

Surveillance Settings
This section will allow users to configure switch settings such as switch IPv4 address
settings, DNS server settings, SNMPT host settings, syslog server, and admin password.
1. Log into your switch management page (see
on page 11).
2. Click on Surveillance Settings.

IP Settings

After you have completed configuration, click Apply and click Save.
Note: After changing IP address settings, you may need to log into the switch with the
new IP address settings. Please also make sure to click Save.
• Address Type: Select Static to manually specify your IP address settings or
Dynamic to allow your switch to obtain IP address settings automatically from a
DHCP server on your network.
• IP Address: Enter the new switch IP address. (e.g. 192.168.200.200)
• Subnet Mask: Enter the new switch subnet mask. (e.g. 255.255.255.0)
• Default Gateway: Enter the default gateway IP address. (e.g. 192.168.200.1 or
typically your router/gateway to the Internet).
• DNS Server 1: Enter the primary IPv4 DNS server address.
• DNS Server 2: Enter the secondary IPv4 DNS server address.
© Copyright 2020 TRENDnet. All Rights Reserved.
"Access your switch management page"

SNMP Host Settings

After you have completed configuration, click Add, Apply, and click Save.
Item Description
Address Type Notify recipients host address type.
Server Address IP address or the hostname of the SNMP trap recipients.
Specify SNMP notification version
•
SNMPv1: SNMP Version 1 notification.
Version
•
SNMPv2: SNMP Version 2 notification.
•
SNMPv3: SNMP Version 3 notification.
Notification Type
•
Trap: Send SNMP traps to the host.
Type
•
Inform: Send SNMP informs to the host.(version 1 have
no inform)
SNMP community/user name for notification. If version
Community/User
is SNMPv3 the name is user name, else is community
name.
SNMP notification packet security level, the security
level must less than or equal to the community/user
name
•
No Security: Specify that no packet authentication is
performed.
Security Level
•
Authentication: Specify that no packet authentication
without encryption is performed.
•
Authentication and Privacy: Specify that no packet
authentication with encryption is performed.
TPE-3012LS / TPE-3018LS
21