Table of Contents
Advertisement
TRENDnet User's Guide
SNMP
Global Settings
System > SNMP > Global Settings
You can manage a switch by viewing and configuring the management information base
(MIB) objects on the device with the Simple Network Management Program (SNMP).
This chapter describes how to configure SNMP. A Group Name, IP address of the switch
and at least one community string is the minimum required to manage the switch using
SNMP.
Note: If you disable the SNMP on the switch, the switch will not be manageable via
SNMP using MIBs.
1. Log into your switch management page (see
on page 7).
2. Click on System, click on SNMP, and click on Global Settings.
3. Review the settings. Click Apply to save changes.
SNMP Global Settings: Click the drop-down list to one of the following options.
o
Enabled - When you enable this parameter, SNMP is active. You can
manage the switch with SNMP network management software and
the switch's private MIB.
o
Disabled - When you select this parameter, SNMP is inactive.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management
page"
Trap Settings: Enable this setting to enable output to a SNMP Trap Host for the
following toggle-able conditions:
o
SNMP Authentication Trap – When a client connects to the switch
with SNMP
o
Port Link Up – When any port on the switch goes from an inactive
state to active.
o
Port Link Down – When any active port on the switch becomes
inactive.
o
ColdStart – When the switch is powered on by connecting to a power
source.
o
WarmStart – When the switch is reboot from a management
interface.
4. Click Apply.
NOTE: The configured settings are only applied to the switch's temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch's NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
TEG-S50ES
13
Advertisement
Table of Contents
