Canon imagePROGRAF W8400 User Manual page 94

Printing with Rolls Media
The table below lists the possible settings for the cut
sheet type.
Media Name
Plain Paper
CAD Plain Paper
Plain Paper(High Quality)
Recycled Coated Paper
Coated Paper
Heavyweight Coated Paper HW Coated
Premium Matte Paper
Extra Heavyweight Coated
Paper
Glossy Photo Paper
Semi-Glossy Photo Paper Semi-Gl Photo
Heavyweight Glossy Photo
Paper
Heavyweight SemiGlos
Photo Paper
Synthetic Paper
Adhesive Synthetic Paper
Backlit Film
Flame-Resistant Cloth
Fabric Banner
Proofing paper
Newsprint for Proofing
Fine Art Photo
Fine Art Heavyweight
Photo
Fine Art Textured
Canvas Matte
Canvas Semi-Glossy
Japanese Paper Washi
Colored Coated Paper
2- 33
Media Type Setting
Plain Paper
CAD Plain Paper
Plain Paper HQ
Recycled Coated
Coated Paper
Premium Matte
Ex HW Coated
Glossy Photo
HW Glossy Photo
HW SemiGl Photo
Syn. Paper
Adh. Syn. Paper
Backlit Film
Flame-Res.Cloth
Fabric Banner
Proofing paper
News Proof 1/2/3
FineArt Photo
FneArt HW Photo
FineArt Txtr
Canvas Matte
Canvas Semi-Gl
JPN Paper Washi
Colored Coated
Media Name
CAD Tracing Paper
CAD Translucent Matte
Film
CAD Clear Film
Special 1-5
Roll media starts to feed as soon as the type of
media is selected.
Important
Make sure to choose the correct media type setting. If
the configured media type is incorrect, perform the
"Media You Can Use" operation. (→ P.2-2)
As soon as each sheet prints, remove it from the output stacker.
Manually remove paper from the ejection guide and
output stacker after cutting such media as trimmed
paper and pre-cut paper.
If you are replacing the roll media, cut off a suitable
amount of paper for the paper type to align the edge of
the paper. Depending on the paper type, the paper
may not be ejected but remain in the printer. If this
happens, remove the paper manually.
Note
If a message appears in the display after loading roll
paper, the operation panel lamp flashes.
The factory default Media Type setting is Plain Paper. Or,
when the release lever is opened and closed, the media
type setting is reset automatically to Plain Paper.
The media size is detected automatically, and so no
settings are required.
If you are replacing the roll media, cut off a suitable
amount of paper for the paper type to align the edge of
the paper. If the roll media remaining amount detection
function is turned ON, the barcode, which is at the edge
of the roll paper, will be cut off after it has been read.
Media Type Setting
CAD Trace Paper
CAD Matte Film
CAD Clear Film
Special 1-5
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index