Connecting The Lan Cable; Tcp/Ip Network Settings (Windows, Macintosh, Unix) - Canon imagePROGRAF W8400 User Manual

TCP/IP Network Settings (Windows, Macintosh, UNIX)

TCP/IP Network Settings (Windows, Macintosh, UNIX)
This chapter describes the configuration procedures for
connecting the printer to a TCP/IP network.
Procedures Required for a TCP/IP
Network
The following is a summary of the procedures required to
set the printer for use on a TCP/IP network.
The following work should be performed by the network
system administrator.
1 Installing the network interface board
First, install the optional network interface board.
2

Connecting the LAN Cable

Connect the printer LAN board to the HUB using a
network cable.
3 Setting the Printer IP Address
Set the printer IP address so that the printer can
communicate with the computer you are using.
Settings can be made using one of the following.
• GARO Device Setup Utility (Canon software
application provided with the printer.)
• ARP/PING command
• Printer Operation Panel
5- 5
4 Installing the Printer Driver
You can use the Canon IMAGEPROGRAF printer
driver for Windows or the Canon IMAGEPROGRAF
printer driver for Macintosh (OS X). Install the printer
driver by following the procedure in the quick start
guide. There is no printer driver for UNIX.
5 Configuring TCP/IP Protocol Settings
Configure the TCP/IP protocol settings as required.
You can use a Web Browser to configure these
settings from your computer.
→ Quick Start
Connecting the LAN Cable
Guide
1
Use a LAN cable to connect the printer LAN
→
P.5-5
port to a port on the hub.
→
P.5-7
a
TOP
トップ
Chapter 1
Basic Use
→ Quick Start
Guide
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
→
P.5-15
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index