Canon imagePROGRAF W8400 User Manual page 335

NetWare Settings (Windows)
Note
The step to use the NetWare file server as the print
server is not required if you intend to use Queue
Server Mode.
This completes the NetWare print service settings. Next,
setup the printer protocols. (→ P.5-40)
If You Are Using the Bindery Queue Server
Mode or Remote Printer Mode
1
Log into NetWare as the Supervisor, then
start PCONSOLE.
2
Switch to the Bindery Mode.
3
If the print server has not been created, use
the following procedure to create the print
server.
From Available Options select Quick Setup
then press the Enter key.
Enter the name of the print server to create,
the name of the new printer, and name of the
queue.
Note
The name of the print server is needed when you
configure the printer protocol settings, so be sure to
note down the printer name.
5- 39
4
Set the printer type.
If using queue server mode, select Other/
Unknown in Type. If you are using remote
printer mode, set Printer Type to Parallel, and
then set Position to Manual Load.
Press the ESC key.
When the confirmation message appears,
select Yes then press the Enter key.
5
Set the password.
From Available Options select Print Servers,
and then press the Enter key.
Select the print server created in
then press the Enter key.
Select Password, and then press the Enter
key. When the password entry screen opens,
enter the desired password, and then press
the Enter key.
6
Press ESC several times to display the
confirmation to close PCONSOLE, then
select Yes to close PCONSOLE.
This completes the NetWare print service settings. Next,
configure the printer protocols. (→ P.5-40)
TOP
トップ
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Step 2, and
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index