Canon imagePROGRAF W8400 User Manual page 355

Message Is Displayed
Illegal Med Pos
Cause 1: The position of the loaded media is incorrect.
Solution 1: Load 10", 14", 16", JIS B2, or ARCH24 roll
paper.
Solution 2: Re-set the roll paper correctly on the roll holder.
(→ P.2-28)
Cause 2: Data for a sheet size that does not permit
borderless printing has been received.
Solution 1: Perform the procedure below to set a paper
width that permits borderless printing.
1. Press and hold the Stop/Eject button for at
least 1 second to stop printing.
2. Change the Roll Width to a size that
permits borderless printing using the printer
driver, and then restart the print job.
NoBorderlessData
Cause 1: Data that does not permit borderless printing
has been received.
Solution 1: Press the Online button to continue printing
with borders.
Solution 2: Perform the procedure below to correct the
Media Type setting on the printer.
1. Press and hold the Stop/Eject button for at
least 1 second to stop printing.
2. Use the printer driver to confirm that the
dimensions of the print job match the
enlargement settings, then re-start the print
job.
6- 8
No borderless
Cause 1: The printer received data that cannot be used
for borderless printing.
Solution 1: Use the following procedure to correct the
Media Type setting on the printer.
1. Press and hold the Stop/Eject button for at
least 1 second to stop printing.
2. Check the dimensions of the print data and
the enlargement/reduction settings in the
printer driver, then reprint the job.
Cause 2: The misalignment detection function is off.
Solution 1: Set the accuracy Skew Check Lv. in the media
type you are printing on to Standard or Loose,
and then reload the paper.
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index