Canon imagePROGRAF W8400 User Manual page 364

Message Is Displayed
Scale Read Error
Cause 1: The carriage has malfunctioned.
Solution 1: Open the top cover and make sure a foreign
object has not fallen into the printer.
Solution 2: Turn OFF the printer, wait for 3 seconds min.,
and then turn ON the printer again.
Solution 3: If the message appears again after doing the
procedure above, read the content of the
message and write down the first line, turn OFF
the printer, and then contact a Canon service
center.
Mist Full Soon
Cause 1: The printer ink mist processing has become full.
(Just before the following "Mist Count Error" is
displayed.)
Solution 1: The current print job can continue. If performing
banner printing or borderless printing, the print
job may stop while incomplete, so contact your
Canon customer service center.
6- 17
Mist Count Error
Cause 1: Printer ink mist processing limit has been
exceeded.
Solution 1: Write the message displayed on the top line of
the printer display on a memo, and then turn
OFF the power supply, and consult your Canon
customer service center.
Cut.Move Timeout
Cause 1: The optional cutter unit (Round cutter) is not
moving.
Solution 1: Open the top cover, and remove the foreign
object from the optional cutter.
Cause 2: The optional cutter unit is broken.
Solution 1: Write the message displayed on the top line of
the printer display on a memo, and then turn
OFF the power supply, and consult your Canon
customer service center.
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index