Canon imagePROGRAF W8400 User Manual page 28

Function Menus
Menu Item
NetWare
NetWare
Frame Type
Print Service
AppleTalk
Ethernet Driver
Auto Detect
Comm. Mode
Ethernet Type
Spanning Tree
MAC Address
Store Setting
Init. Settings
Maintenance
1- 25
Setting Values
Off*, On
Auto Detect, Ethernet 2, Ethernet
802.2*, Ethernet 802.3, Ethernet SNAP
BindaryPserver, RPrinter,
NDSPserver*, Nprinter
On, Off*
On*, Off
Half Duplex*, Full Duplex
10 Base-T*, 100 Base-TX
Not Use*, Use
Ok?
Ok?
Function
Sets the network interface for NetWare
protocol. After configuring all of the settings,
select Store Setting to save the settings and
enable them. This menu is displayed only when
the network interface is installed. (→ P.5-35)
Determines whether the NetWare protocol is
used.
Selects the frame type to use.
Selects the print service.
Determines whether AppleTalk protocol is
used. After configuring all of the settings, select
Store Setting to save the settings and enable
them. This menu is displayed only when the
network interface is installed. (→ P.5-30)
Sets the method of communication for the network
interface board. After configuring all of the settings,
select Store Setting to save the settings and enable
them. This menu is displayed only when the network
interface is installed. (→ P.5-6)
Sets the network card to automatically detect
the LAN communication protocol. If set to OFF,
the communication method and Ethernet type
setting values are enabled.
Selects the LAN communication method.
Selects the LAN communication method.
This selection determines whether the LAN spanning
tree packets are received and supported.
Displays the MAC address of the network
interface board.
Resets all of the Interface Setup settings to
their factory defaults.
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index