Canon imagePROGRAF W8400 User Manual page 362

Message Is Displayed
Turn Power Off!!
Cause 1: The tape inside the top cover or the belt stopper
have not been removed.
Solution 1: Turn OFF the printer, open the top cover,
remove the tape and belt stopper, and then
press the Power button. (→ Quick Start Guide)
Cause 2: Media has jammed in the printer.
Solution 1: Turn OFF the printer and remove the jammed
sheet, reset the media, and then turn ON the
printer again. (→ P.6-37)
Cause 3: The printer has malfunctioned.
Solution 1: Turn OFF the printer, wait for 3 seconds min.,
and then turn ON the printer again.
6- 15
Solution 2: If the message appears again after doing the
ERROR E02E01
Turn Power Off!!
procedure above, read the content of the
message and write down the first line, turn OFF
the printer, and then contact a Canon service
center.
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index