Canon imagePROGRAF W8400 User Manual page 357

Message Is Displayed
Media Too Large
Cause 1: The loaded media is larger than any media size
allowed for loading in the printer.
Solution 1: Set the correct size media then try again.
(→ P.2-28, P.2-38)
Media Too Small
Cause 1: The loaded media is smaller than any media
size allowed for loading in the printer.
Solution 1: Set the correct size media then try again.
(→ P.2-28, P.2-38)
Cause 2: Media size smaller than the required size was set for
printing the print pattern or the nozzle check pattern.
Solution 1: Load A3 size media or larger for printing.
Media Jam
Cause 1: Media has jammed in the printer.
Solution 1: Perform the procedure described below to
remove the jammed sheet. (→ P.6-37)
1. Switch the printer off.
2. Remove the jammed sheet.
3. Turn ON the power supply.
6- 10
Cut Failed
Cause 1:
Solution 1: Perform the procedure described below to
Drying..
Cause 1:
Solution 1: Wait until the printed sheet ejects automatically.
Feed Limit..
Cause 1:
Solution 1: Remove your finger from the [
ERROR E02E01
Turn Power Off!!
Cut by Stop key
Cause 1:
Solution 1: The printer stops after the print job ends to
Leading edge of the roll media not detected
after cutting.
remove the jammed sheet. (→ P.2-35)
1. Open the top cover.
2. Use a cutter to cut the roll media manually,
and then remove the sheet.
3. Lift the release lever.
4. Reload the roll media, and then lower the
release lever.
5. Close the top cover.
The printer is waiting for the ink to dry on the
printout.
You pressed the [ ] button on the operation
panel to feed more media than allowed.
the paper feed.
The loaded media cannot be cut automatically.
protect the printing surface. Support the printout
with your hand to prevent it from falling into the
output stacker, and then press the Stop/Eject
button to cut the printout.
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
] button to stop
Chapter 7
Operating the
Function Menu
Contents
Index