Canon imagePROGRAF W8400 User Manual page 93

Printing with Rolls Media
9
Hold the end of the paper, and lift the release
lever.
10
While gently pulling out the center of the
leading edge of the roll media to the ejection
guide (f), align the right edge of the media
with the right side of the paper alignment line
(g), then pull down the release lever.
Important
Make sure to carry out
paper may not be feed straight, or the paper may
become wrinkled causing a paper jam or friction on the
printhead.
Do not pull strongly on the roll media when you align it
with the paper alignment line (g). The roll media may
not feed out straight in some cases.
2- 32
g
f
Step 9 and 10. Otherwise, the
Note
If the release lever is open, the platen paper suction
can be adjusted. If it is difficult to load the paper, adjust
the suction using the [ ] button (stronger) and [
button (weaker) on the operation panel.
11
Close the top cover.
Media Type is displayed.
12
Press the [ ] or [
loaded media type, and then press the OK
button.
If the same type of media already matches the
loaded media, just press the OK button.
Media Type
HW Coated
The selection is prefixed with an equals sign (=) to
indicate the roll media type that is selected.
]
] buttons to select the
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index