Canon imagePROGRAF W8400 User Manual page 356

Message Is Displayed
Size undetected
Cause 1: The media has shifted out of the correct load
position, or the media is curled.
Solution 1: Set the media correctly. (→ P.2-28, P.2-38)
Cause 2: The printer interior is dusty or dirty.
Solution 1: Open the top cover and clean inside the printer.
(→ P.4-11)
6- 9
Media Skewed
Cause 1: The loaded media is skewed.
Solution 1: If using roll media, perform the procedure
described below to reload the roll media.
(→ P.2-28)
1. Open the top cover.
2. Press the release lever to the rear to open.
3. Align the right edge of the roll media so that
it is parallel to the right paper alignment line,
then pull the release lever to the front to
close.
4. Close the top cover.
5. Select the Media Type and press the OK
button.
Solution 2: Perform the procedure below if you are using
cut sheets. (→ P.2-38)
1. Open the top cover.
2. Press the release lever to the rear to open.
3. Align the right edge of the cut sheet with the
right side, align the leading edge of the
sheet inside the printer, then pull the release
lever toward you to close.
4. Close the top cover.
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index