Canon imagePROGRAF W8400 User Manual page 29

Function Menus
Menu Item
Replace P.head
Move Printer
System Setup
Warning
Buzzer
Head Ht. Wrning
Med.type Wrning
Change Cutter
Keep Media Size
1- 26
Setting Values
No, Yes
No, Yes
On*, Off
ON*, OFF, Check Head Hght
On*, Off
No, Yes
Off*, On
Function
Performs the processing required for printhead
replacement. This menu is not displayed if the
maintenance cartridge capacity warning is
displayed. (→ P.4-21)
Performs the processing required before
transporting the printer to another location. This
menu is not displayed if the maintenance cartridge
capacity warning is displayed. (→ P.4-33)
Sets the buzzer function. When set to On, the
buzzer sounds when an error occurs.
Determines whether a prompt is issued when
the printhead is not at the correct height for the
print media.
Determines whether a warning is issued when
the media loaded in the printer does not match
the media specified for the print job.
Prepares the printer so the cutter can be
replaced when replacement is necessary. After
replacement, you can reset the number of cuts.
When set to On, printing is performed
according to the specified paper size. The
image may extend beyond the top, bottom,
right, and left edges.
Important
If set to Off, the image will be printed cleanly,
leaving the recommended 5-mm border at the
top, bottom, right, and left edges. However, a
long sheet with ample top, bottom margins
should be used.
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index