Configuring Basic Snmp Functions - 3Com 4210 PWR Configuration Manual

Configuring Basic
SNMP Functions
Table 272 Common MIBs
MIB attribute
Private MIB
SNMPv3 configuration is quite different from that of SNMPv1 and SNMPv2c.
Therefore, the configuration of basic SNMP functions is described by SNMP
versions, as listed in Table 273 and Table 274.
Table 273 Configure basic SNMP functions (SNMPv1 and SNMPv2c)
Operation
Enter system view
Enable SNMP agent
Set system information, and specify
to enable SNMPv1 or SNMPv2c on
the switch

Configuring Basic SNMP Functions

MIB content
DHCP MIB
QACL MIB
MSTP MIB
VLAN MIB
IPV6 ADDRESS MIB
MIRRORGROUP MIB
QINQ MIB
802.x MIB
Switch Clustering MIB
NTP MIB
Device management
Interface management
Command
system-view
snmp-agent
snmp-agent sys-info {
contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }* |
all } }
353
Related RFC
-
Description
-
Optional
Disabled by default.
You can enable SNMP
agent by executing this
command or any of the
commands used to
configure SNMP agent.
Required
By default, the contact
information for system
maintenance is "R&D
Hangzhou, 3Com
Technology Co., Ltd.",
the system location is
"Hangzhou China", and
the SNMP version is
SNMPv3.