6. Using the Integral Modem
Table 6-1.
Initiating a Call for Front Panel Pass-Through Operation
Front panel pass-through initiates a call through the integral modem to access a
far-end CSU's front panel from your CSU's front panel (or PC attached to the COM
port).
The pass-through feature is not available (and is not displayed) on carrier-
mounted CSUs.
6-4
Valid Phone Number Characters
Valid
Characters
Meaning
0 to 9
DTMF or pulse digits
* #
DTMF digits
P
Selects Pulse dialing
T
Selects Tone (DTMF) dialing
W
Wait for dial tone
B
Blind dialing (you need not wait for
a dial tone before entering the
dialing sequence)
,
Creates a 2-second pause in the
dialing sequence
<space> ( )
Extra characters for readability. The
-
space is the default character.
<-
End Of Number (EON) character,
terminates the dial string and
erases all characters to the right
after F3 (Save) is pressed
NOTE:
Pass is only available when the FP Pass configuration option has been
Appendix C, Configuration
enabled (see
is either the front panel or the PC, and the integral modem is not already in
use.
March 2001
Restrictions
—
—
Pulse or Tone must be specified,
otherwise Tone is the default. This
must be the first character in the
string, unless the first character is B.
Then, it must immediately follow
the B.
Tone or Pulse must be specified,
otherwise Tone is the default. This
must be the first character in the
string, unless the first character is B.
Then, it must immediately follow
the B.
—
To be valid, this must be the first
character in the string.
—
—
—
Options), the active physical interface
3150-A2-GB24-10