Paradyne 3150 Operator's Manual page 174

F. SNMP MIB Objects
Interface Group – "ifMtu" Object (ifEntry 4)
This object identifies the largest datagram that can be sent or received on the
interface. It is applicable only to the interface configured as the SNMP
management link. This object is zero for all other interfaces.
Interface Group – "ifSpeed" Object (ifEntry 5)
This object provides the interface's current bandwidth in bits per second. The
value of this object for each interface is specified as follows:
Interface Group – "ifAdminStatus" Object (ifEntry 7)
This object specifies the desired state (configuration) of the interface. This object
is supported only for the COM and MODEM ports. It provides the ability to switch
between using the port for SNMP or ASCII operations (dial-out, front panel
emulation). The value of this object will not affect the state of any of the interfaces
on the CSU other than the COM or MODEM port. Only the following values are
supported by the CSU:
T
T
Interface Group – "ifOperStatus" Object (ifEntry 8)
This object specifies the current operational state of the interface. The value of this
object for each interface is defined as follows:
F-6
T1 Interfaces: 1,544,000 bps.
COM and MODEM: The currently configured data rate for the port.
up(1) – The SNMP management link is active on the COM or MODEM ports.
testing(3) – The SNMP management link is inactive on the COM or MODEM
ports. These ports can be used for proprietary ASCII functions.
Network T1: The interface is up(1) when no alarm conditions exist.
The interface is down(2) when an alarm condition is active.
The interface is testing(3) when a test is active on the
interface.
DTE T1: The interface is up(1) when no alarm conditions exist and
the interface is enabled.
The interface is down(2) when an alarm condition is active
and the interface is disabled.
The interface is testing(3) when a test is active on the
interface.
March 2001 3150-A2-GB24-10