Paradyne 3150 Operator's Manual page 178

F. SNMP MIB Objects
IP Group – "ipRouteIfIndex" Object (ipRouteEntry 1)
When the routing table is displayed, the ipRouteIfIndex object for some entries
may have a value greater than ifNumber. In these cases, the ipRouteIfIndex refers
to a proprietary interface which is not currently implemented by the interface group
of MIB II. Route entries with an unrecognized ipRouteIfIndex value should not be
deleted.
When setting this object via SNMP, the ipRouteIfIndex value can only assume an
appropriate value of ifIndex defined for the particular device type.
IP Group – "ipRouteMetric2" Object (ipRouteEntry 4)
The following values are displayed for the ipRouteMetric2 object. For a carrier
device designated as the IP Bus Master, ipRouteMetric2 is used to designate the
slot number of the next hop associated with this route if the destination is not
connected to the device. For carrier devices not designated as the IP Bus Master
or IP Bus Master devices in which the destination is connected to the device,
ipRouteMetric2 contains the slot number (0–15) of the carrier device. For
standalone devices, ipRouteMetric2 is not used and contains –1.
When adding a route to the routing table using SNMP, do not specify a value for
ipRouteMetric2.
IP Group – "ipRouteProto" Object (ipRouteEntry 9)
This object is a read-only object and may have the following values in the CSU.
T
T
T
T
T
IP Group – "ipRouteAge" Object (ipRouteEntry 10)
This object is implemented as a read-only object in the CSU. In the CSU, it reflects
the value of the route's time-to-live (in seconds). When displays, a value of 999
represents a route that is retained permanently. For temporary routes, the
ipRouteAge object decrements over time. All routes added via an SNMP set of the
ipRouteTable are considered permanent routes. These routes do not age, but will
remain unless deleted via SNMP.
F-10
other(1) – Temporary route added by IP.
local(2) – Route added or modified as a result of user configuration via the
front panel.
netmgmt(3) – Route added or modified by means of an SNMP set.
icmp(4) – Route added or modified by Internet Control Management Protocol
(ICMP).
rip(8) – Route added or modified by Routing Information Protocol (RIP) (or
similar proprietary protocol).
March 2001 3150-A2-GB24-10