Initiating A Call For Pc, Ascii Terminal/Printer, Or Snmp Operation - Paradyne 3150 Operator's Manual

6. Using the Integral Modem
Initiating a Call for PC, ASCII Terminal/Printer, or SNMP
Operation
Use the Dial command to set up a semipermanent connection to route alarm
messages to the specified destination. The Dial command initiates a call through
the integral modem to a printer, ASCII terminal, or PC.
Procedure
To initiate a call at the local CSU:
6-6
1. From the top-level menu screen, press the
appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
Control:
Call Rel
F1 F2
4. From the Call Setup screen, select Dial. This selection is not available if the
CSU's integral modem is already in use.
Call Setup:
Pass Dial
F1 F2
5. From the Dial Directory screen, press F1 (Up) to display the next higher
numbered directory or press F2 (Down) to select the next lower numbered
directory.
Dial n : xxxxxxxxx
Up Down
F2
F1
6. When the number of the desired directory appears on the screen, press F3
(Dial) to place the call.
Dial n : xxxxxxxxx
Up Down
F1 F2
March 2001
key until the Ctrl selection
ClrReg
F3
ChDir
F3
Dial
F3
Dial
F3
3150-A2-GB24-10