Initiating A Call For Front Panel Pass-Through Operation; Initiating A Call For Pc, Ascii Terminal/Printer, Or Snmp Operation - Paradyne 3150 Operator's Manual

Initiating a Call for Front Panel
Pass-Through Operation
Front panel pass-through initiates a call through the
integral modem to access a far-end CSU's front panel
from your CSU's front panel (or PC attached to the COM
port).
The pass-through feature is not available (and is not
displayed) on carrier-mounted CSUs.
NOTE
Pass is only available when the
FP Pass configuration option has
been enabled (see Appendix C,
Configuration Options), the active
physical interface is either the
front panel or the PC, and the
integral modem is not already in
use.
To initiate front panel pass-through at the near-end
CSU,
1. From the top-level menu screen, press the
until the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
Control:
Call
F1
4. From the Call Setup screen, select Pass.
Call Setup:
Pass
F1
3150-A2-GB21-80
key
Rel ClrReg
F3
F2
Dial ChDir
F3
F2
February 1998
5. From the Pass Directory screen, press F1 (Up) to
display the next higher numbered directory or
press F2 (Down) to select the next lower
numbered directory.
Pass n : xxxxxxxxx
Up
F1
6. When the number of the desired directory appears
on the screen, press F3 (Dial) to place the call.
Pass n : xxxxxxxxx
Up
F1
Initiating a Call for PC, ASCII
Terminal/Printer, or SNMP Operation
Use the Dial command to set up a semipermanent
connection to route alarm messages to the specified
destination. The Dial command initiates a call through the
integral modem to a printer, ASCII terminal, or PC.
To initiate a call at the local CSU,
1. From the top-level menu screen, press the
until the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
Control:
Call
F1
Operation
Down Dial
F2 F3
Down Dial
F2 F3
key
Rel ClrReg
F2 F3
3-23