Paradyne 3150 Operator's Manual page 148

C. Configuration Options
Table C-6. General Management Configuration Options (6 of 6)
C-26
Modem Link: PPP
Next PPP SLIP Prev
Modem Port Link Layer Protocol. Specifies the link layer protocol for the modem port if the
Modem Use configuration option is set to Mgmt.
–
PPP Specifies PPP as the link layer protocol for the IP management link on the modem
port.
–
SLIP Specifies SLIP protocol as the link layer protocol for the IP management link on
the modem port. The modem port must be configured for asynchronous operation to
support SLIP.
NOTE: This configuration option is available on standalone CSUs only.
IPBusMast: Disab
Next Enab Disab Prev
Setting the IP Bus Master. Specifies whether or not a particular carrier-mounted unit is
the IP Bus Master. There can only be one IP Bus Master per 3000 Series Carrier.
Typically, the carrier-mounted unit that has the SNMP/Telnet management system
connected to it is the IP Bus Master. This allows for faster access to the remaining carrier
units. If an SNMP/Telnet management system is connected to another carrier-mounted
unit (i.e. not the IP Bus Master) and the SNMP/Telnet management system tries to
access another carrier-mounted unit, the data has to be routed to the IP Bus Master first.
Once the IP Bus Master receives the data, it is routed to the appropriate slot.
–
Enab This unit is the IP Bus Master. Only one IP Bus Master is allowed per 3000 Series
Carrier.
–
Disab This unit is not the IP Bus Master.
NOTE: This configuration option is available on carrier-mounted CSUs only.
Def Netwk: None
Next None IPBus Com
Default Network Destination. Specifies the default network destination. This configuration
option specifies where the default network is connected. For example, if the default
network is connected to the communication port, you select Com. If the default network is
connected to the far-end 31xx Series device over the FDL, you select FDL. The routing
protocol uses the default network destination to route data that does not have a specific
route.
–
None No default network destination. Data that cannot be routed is discarded.
–
IPBus The default network destination is the IP Bus on the carrier backplane. This
selection appears only for carrier-mounted CSUs which are not configured as the IP Bus
Master.
–
Com The default network destination is the communication port. This selection appears
only if the Com Use configuration option is set to Mgmt.
–
Modem The default network destination is the modem port. This selection appears only
if the Modem Use configuration option is set to Mgmt. This selection does not appear on
carrier-mounted CSUs.
–
FDL The default network destination is FDL. This selection appears only if the FDL
management link is enabled.
NOTE: If the chosen default network link is disabled or down, data is discarded. Return
to this menu and choose another default network.
March 2001
Modem FDL Prev
3150-A2-GB24-10