Using the Front Panel
Overview
This chapter shows how to use:
T
T
Front Panel
The standalone CSU front panel
consists of an LCD, a keypad, test jacks, and 12 LEDs. The carrier-mounted CSU
faceplate contains test jacks and 12 LEDs, however, the LCD and keypad are
located on the Shared Diagnostic Control Panel (SDCP) of the 3000 Series
Carrier. For more information about the SDCP, refer to the
Series Carrier Installation Manual
3150-A2-GB24-10
The standalone CSU front panel and 3000 Series Carrier control panel to:
— Display unit identity
— Reset the CSU
The front panel LEDs to:
— Monitor the status of the CSU
— Monitor the status of the network
— Monitor the status of the DTE
NOTE:
Additional information for the carrier-mounted CSU is located in the
ACCULINK 3151 CSU and 3161 DSU/CSU General Information Guide
the
COMSPHERE 3000 Series Carrier Installation Manual
NOTE:
You can display a graphical representation of the CSU front panel on an
attached PC (see
Appendix H, Front Panel Emulation
March 2001
(Figure 3-1, Standalone CSU Front
.
).
3
and
.
Panel)
COMSPHERE 3000
3-1