Table of Contents
Advertisement
Front Panel Indicator Lights
Model 6512 shown. All of the SuperLine IAD's indicators turn ON and OFF during the
power-on self-test. After a successful power-on self-test, the SuperLine IAD's indicators
should appear as indicated in BOLD in the Condition column of the following table:
Indicator
Condition Status
PWR
ON
ALM
OFF
ON
TST
OFF
ON
LINE
ON
OFF
ETHERNET
ON
(Models
OFF
6510, 6511,
6512 only)
Under normal operation, if the PWR and LINE indicators are on you should be able to
use your new phone lines. The ETHERNET indicator state depends on the equipment
you have connected to your SuperLine IAD. The TST and ALM indicators can be
initiated by your service provider. For conditions other than these, refer to
Troubleshooting Your SuperLine IAD on page 25 for indicators requiring action.
Power – Green
Alarm – Red
®
PWR
ALM
6512
TM
Power is applied to the SuperLine IAD.
No active alarms.
An alarm condition exists which may require further
attention. Refer to Troubleshooting Your SuperLine IAD
on page 25.
No active tests.
The TST indicator is ON during the power-on self-test and
during testing or upgrades initiated by your service
provider. Additional lines are not available when the TST
indicator is ON. Your existing (BASE) phone still works.
Your SuperLine IAD is connected to your local phone
company and is ready to use.
The link has not been established.
The Ethernet connection to your PC or Ethernet Hub is
made and your PC is ON.
No Ethernet device is detected.
28
Test – Yellow
Line – Green
TST
LINE
Ethernet – Green
ETHERNET
99-16016a-02
Advertisement
Table of Contents
