Displaying Csu Test Status - Paradyne 3150 Operator's Manual

Displaying CSU Test Status

Use the Test Status command to display the active tests for the CSU. Status
messages that can display on the front panel LCD are listed in
Status
Procedure
To display test status:
Table 8-3.
3150-A2-GB24-10
Messages.
1. From the top-level menu screen, select Stat.
2. From the Status screen, press the
the screen.
3. Select TStat.
Status:
STest Perf
F1
The Test Status screen appears showing you what tests are active for the
CSU.
Test Status Messages
Message Description
No Test Active No tests are currently active.
LLB Test Active The network interface is in Line loopback.
PLB Test Active The network interface is in Payload loopback.
DLB Test Active The DTE port is in DTE loopback.
RLB Test Active The DTE port is in Repeater loopback.
QRSS on Net A QRSS test pattern is being sent on the network interface.
1–8 Test Active A 1-in-8 test pattern is being sent on the network interface.
Mon QRSS, Net A QRSS test pattern is being monitored on the network
interface.
DLB Test, Extrn The DTE port is being held in DTE loopback by the external
contact.
Lamp Test Active The Lamp test is currently active.
March 2001
key until the TStat selection appears on
TStat
F2 F3
8. Testing
Table 8-3, Test
8-17