Paradyne 3150 Operator's Manual page 173

The supported ifIndexes for the 3150 CSU are:
T
T
T
T
The supported ifIndexes for the 3151 CSU are:
T
T
T
Interface Group – "ifDescr" Object (ifEntry 2)
This object provides information about the interface. Each interface displays a text
string as shown below:
Interface Group – "ifType" Object (ifEntry 3)
This object identifies the type of the interface based on the physical/link protocol(s)
immediately below the network layer. Only the following values are supported by
the CSU:
T
T
T
T
3150-A2-GB24-10
Net T1
DTE T1
COM port
Modem port
Net T1
DTE T1
COM port (if configured)
Network T1: "Network T1. [ Company Name ] T1 CSU, Hardware
Version: [CCA number for the CSU board]".
DTE T1: "DTE T1. [ Company Name ] T1 CSU, Hardware Version:
[CCA number for the CSU board]".
COM: "COM port. [ Company Name ] T1 CSU, Hardware Version:
[CCA number for the CSU board for the standalone, or the
CCA number for the DSU board for the carrier]".
Modem: "MODEM port. [ Company Name ] T1 CSU, Hardware
Version: [CCA number for the CSU board]".
ds1 – Used for the network and DTE interfaces.
propPointToPointSerial(22) – Used for the MODEM or COM port when the port
is not configured as the SNMP management interface.
ppp(23) – Used for the MODEM or COM port when the port is configured for
PPP.
slip(28) – Used for the MODEM or COM port when the port is configured for
SLIP.
March 2001
F. SNMP MIB Objects
F-5