Enterprise Mib; T Correlation Between Menu Commands And Snmp Objects - Paradyne 3150 Operator's Manual

Generic Interface Test Table – "ifExtnsTestCode" Object
(ifExtnsTestEntry 6)
This object contains a code that contains more specific information on the test
result. This object is defined as an object identifier. Only the following values are
supported by the CSU.
T
T
T
T
Where these object identifiers are defined as follows:
T
T
T
T
T

Enterprise MIB

The variable devConfigAreaCopy under the devConfigArea group in the common
area of the Enterprise MIB will be fully supported. This variable allows the entire
contents of one configuration area to be copied into another configuration area.
Correlation between Menu Commands and SNMP Objects
Table F-1, SNMP MIB to Front Panel Command
correlation between how a function is performed or status is displayed on the front
panel and how the same function is accomplished using access to the SNMP
database. SNMP objects are displayed in bold type while values for SNMP
objects are displayed in italics.
3150-A2-GB24-10
none – No further information is available. Used for the send pattern/code and
loopback tests.
inSyncNoBitErrors – A monitor pattern (QRSS or 511) test has synchronized
on the pattern and has not detected any bit errors.
inSyncWithBitErrors – A monitor pattern (QRSS or 511) test has synchronized
on the pattern and has detected bit errors.
notInSync – A monitor pattern (QRSS or 511) test has not synchronized on
the requested pattern.
wellKnownCodes – OBJECT IDENTIFIER ::= [ifExtensions 5]
none – OBJECT IDENTIFIER ::= [wellKnownCodes 1]
inSyncNoBitErrors – OBJECT IDENTIFIER ::= [wellKnownCodes 2]
inSyncWithBitErrors – OBJECT IDENTIFIER ::= [wellKnownCodes 3]
notInSync – OBJECT IDENTIFIER ::= [wellKnownCodes 4]
March 2001
F. SNMP MIB Objects
Cross-Reference, provides a
F-21