Paradyne 3150 Operator's Manual page 138

C. Configuration Options
Table C-4. User Interface Configuration Options (10 of 10)
C-16
DefGatewayAdr: 000.000.000.000
Next Edit Clear Prev
Default Gateway Address. Specifies the address (normally the address of a router) where
messages for other subnets are sent.
–
Edit Allows you to edit and/or display the default gateway address.
–
Clear Allows you to clear the default gateway address. The address is set to
000.000.000.000.
NOTE: This configuration option is not displayed if 10BaseT port use (ENET Use) is
disabled. It is available on standalone CSUs only.
TnSession: Disab
Next Enab Disab Prev
Telnet Session Enable. Specifies whether the CSU responds to Telnet session requests.
–
Enab The CSU responds to Telnet session requests.
–
Disab The CSU does not respond to Telnet session requests.
TnPaswd: Disab
Next Enab Disab Prev
Telnet Password Mode. Specifies whether a password is required for Telnet access.
–
Enab A password is required for Telnet access.
–
Disab A password is not required for Telnet access.
TnInActTm: Disab
Next Enab Disab Prev
Telnet Inactivity Timeout. Specifies whether the Telnet session disconnects after a period
of inactivity specified by the TnDiscTm configuration option.
–
Enab The Telnet session disconnects after the period of inactivity specified by the
TnDiscTm configuration option.
–
Disab The Telnet session does not disconnect due to inactivity.
TnDiscTm: 5
Next Up Down Save
Telnet Disconnect Time. Specifies the period of time (1 to 60 minutes) before the Telnet
session disconnects due to inactivity. (The TnInActTm configuration option must be set to
Enab.) Use the left or right arrow key to position the cursor on the digit you want to
change. Use the Function keys (Up or Down) to increment or decrement the digit.
–
Up Increments the time delay.
–
Down Decrements the time delay.
–
Save Stores the time delay for use with inactivity disconnects.
March 2001
Prev
3150-A2-GB24-10