Paradyne 3150 Operator's Manual page 146

C. Configuration Options
Table C-6. General Management Configuration Options (4 of 6)
C-24
NetMask:
Next Edit Clear Prev
Subnet Mask for the CSU. Specifies the subnet mask needed to access the CSU. Since
this subnet mask is not bound to a particular port, it can be used for remote access via
the FDL management link.
–
Edit Allows you to edit and/or display the subnet mask for the CSU.
–
Clear Allows you to clear the subnet mask for the CSU. The subnet mask is set to
000.000.000.000. If the subnet mask is 000.000.000.000, the IP protocol creates a
default subnet mask based on the class of the IP address (Class A: 255.000.000.000,
Class B: 255.255.000.000, or Class C: 255.255.255.000).
Com IP Adr:
Next Edit Clear Prev
Com Port IP Address. Specifies the IP address for the communication port if the Com
Use configuration option is set to Mgmt.
–
Edit Allows you to edit or display the IP address for the communication port.
–
Clear Allows you to clear the IP address for the communication port. The IP address is
set to 000.000.000.000.
NOTE: This configuration option is not available on carrier-mounted CSUs if the
communication port is disabled.
Com NetMask:
Next Edit Clear Prev
Subnet Mask for the Communication Port. Specifies the subnet mask for the
communication port if the Com Use configuration option is set to Mgmt.
–
Edit Allows you to edit and/or display the subnet mask for the communication port.
–
Clear Allows you to clear the subnet mask for the communication port. The subnet
mask is set to 000.000.000.000. If the subnet mask is 000.000.000.000, the IP protocol
creates a default subnet mask based on the class of the IP address
(Class A: 255.000.000.000, Class B: 255.255.000.000, or Class C: 255.255.255.000).
NOTE: This configuration option is not available on carrier-mounted CSUs if the
communication port is disabled.
Com Link: PPP
Next PPP SLIP Prev
Com Port Link Layer Protocol. Specifies the link layer protocol for the communication port
if the Com Use configuration option is set to Mgmt.
–
PPP Specifies PPP as the link layer protocol for the IP management link on the
communication port.
–
SLIP Specifies SLIP as the link layer protocol for the IP management link on the
communication port. The communication port must be configured for asynchronous
operation to support SLIP.
NOTE: This configuration option is not available on carrier-mounted CSUs if the
communication port is disabled.
March 2001 3150-A2-GB24-10