Generic-Interface Mib Extensions (Rfc 1229); Generic Interface Test Table, Generic Interface Mib - Paradyne 3150 Operator's Manual

F. SNMP MIB Objects

Generic-Interface MIB Extensions (RFC 1229)

The generic-interface MIB is an experimental MIB that provides extensions to the
generic interface group defined in MIB II. This MIB describes three tables:
T
T
T
Only the generic interface test table is supported by the CSU. This table is
supported for the network interface only.

Generic Interface Test Table, Generic Interface MIB

The test table provides access to additional tests (loopbacks and pattern tests)
that are not in the interface group of MIB II.
Generic Interface Test Table – "ifExtnsTestType" Object (ifExtnsTestEntry 4)
This object is a control variable used to start and stop operator-initiated tests on
the interface. It provides the capability to:
T
The following object identifiers are used to control the tests on the interface.
T
T
Where these object identifiers are defined as follows:
T
Generic Interface Test Table – "ifExtnsTestResult" Object
(ifExtnsTestEntry 5)
This object contains the result of the most recently requested test. Only the
following values are supported by the CSU.
T
T
T
T
F-20
Generic Interface Extension Table
Generic Interface Test Table
Generic Receive Address Table
Start/stop the Monitor QRSS test pattern on the network interface.
noTest – Stops the test in progress on the interface.
testMonQRSS – Initiates a Monitor QRSS test on the interface. Supported for
the network interface.
testMonQRSS – OBJECT IDENTIFIER ::= [wellKnownTests 3]
none(1) – No test currently active.
inProgress(3) – A test is currently in progress.
notSupported(4) – The requested test is not supported.
unAbleToRun(5) – The requested test cannot run due to the state of the unit.
March 2001 3150-A2-GB24-10