Paradyne 3150 Operator's Manual page 135

Table C-4. User Interface Configuration Options (7 of 10)
3150-A2-GB24-10
CmInActTm: Disab
Next Enab Disab Prev
Communication Port Inactivity Timeout. Specifies whether the communication port
disconnects after a period of inactivity specified by the CmDiscTm configuration option.
–
Enab The communication port disconnects after the period of inactivity specified by the
CmDiscTm configuration option.
–
Disab The communication port does not disconnect due to inactivity.
CmDiscTm: 5
Next Up Down Save
Communication Port Disconnect Time. Specifies the period of time (1 to 60 minutes)
before the communication port disconnects due to inactivity. (The CmInActTm
configuration option must be set to Enab.) Use the left or right arrow key to position the
cursor on the digit you want to change. Use the Function keys (Up or Down) to increment
or decrement the digit.
–
Up Increments the time delay.
–
Down Decrements the time delay.
–
Save Stores the time delay for use with inactivity disconnects.
Modem Use: ASCII
Next Mgmt ASCII Term
Modem Port Use. Specifies how the modem port is used.
–
Mgmt Configures the modem port as the link to an SNMP or Telnet system.
–
ASCII Configures the modem port as a proprietary ASCII port. This selection supports
dial-out ASCII alarm messages and dial-in/dial-out front panel access.
–
Term Configures the modem port as the interface to an async terminal.
NOTE: This configuration option is available on standalone CSUs only.
Modem Type: Async
Next Async Sync Prev
Modem Type. Specifies whether the port uses synchronous or asynchronous
communication if the modem port is configured as the SNMP management link.
NOTES:
– This configuration option is available on standalone CSUs only.
– This configuration option is not available if the Modem Use configuration option is
set to ASCII. In this case, the modem port is always asynchronous.
Modem Rate: 2.4
Next 1.2 2.4 Prev
Modem Port Rate. Configures the bit rate for the modem port.
–
1.2 Sets the bit rate at 1200 bps.
–
2.4 Sets the bit rate at 2400 bps.
NOTE: This configuration option is available on standalone CSUs only.
March 2001
Prev
Prev
C. Configuration Options
C-13